Bend Testing Services
ITE’s Destructive Testing Lab Division which has been accredited by National Accreditation Board for Testing and Calibration Laboratories (NABL) as per ISO 17025 in the field of Chemical & Mechanical Testing of Metals. This is the highest accreditation granted to laboratories working in the domain of Material Testing and Calibration services.BEND TESTS are conducted to determine the ductility or strength of a material.Bend tests for ductility differ fundamentally from other mechanical tests in that most mechanical tests are designed to give a quantitative result and have an objective endpoint. In contrast, bending ductility tests give a pass/fail result with a subjective endpoint; the test operator judges whether a surface has undergone cracking. The bending ductility test developed as a shop-floor material inspection test because of its pass/fail qualities and the simplicity and low cost of the required tooling. As a consequence, the development of bending ductility test methods and apparatuses has been carried out by users rather than by mechanical-test equipment manufacturers. Test procedures and specimen preparation methods have evolved without close attention to detail. Therefore, despite the value of the test and its long history of use, there has been minimal standardization.Description and requirements of bend test is given in various other standards like ASME Section IX, AWS D1.1, IS 1599, IS 2062, ASTM A 370, etc.
|Sampling Procedure||On-Site Testing|
|Testing Parameter||Sulphur Content|
|Preferred Analysis Technique||Resistant|
|Client Profile||Building Owner|
|Value Data Report on||Material Properties|
|Certification Scheme||Employer Based Certification|
|Testing Type||Bearing Capacity Testing|
|Product Type||Concrete Mix Design|
determines the ductility or the strength of a material by bending the material over a given radius. Following the bend, the sample is inspected for cracks on the outer surface. Bend testing provides insight into the modulus of elasticity and the bending strength or a material. Metallurgical offers three and four point bend setups with interchangeable rollers for a variety of test configurations.
|Mode of Report||Soft Copy|
|Test Location||Customer Place|
|Application / Industry||Industrial|
We are the leading organization to offer our precious clients an optimum quality Bend Testing Services
Looking for Bend Testing Services ?